Thread: 300 Rum Brass Cases

Originally Posted by veitnamcam

Na you didn't you posted two loads with no pressure data and didn't state if they were any chamber powder brass primer changes just this one is more powder and less pressure.

I can put 52 gr of 2208 in a 308 case with no pressure signs but i sure as Fuck wouldn't even try that with n140 both of which are the same proposed burn rate .



Sent from my GT-S5360T using Tapatalk 2

Originally Posted by tui_man2

For sake of it pet load was 96gr, 2225, 215 primer, otm seated at 3.97"

New load is same but 100gr an 4.05"

There i said it.......in the first post

SAME primer
SAME cases
SAME powder
SAME projectile
MORE powder

So where did the excuess pressure go?
Why would i tell everyone the little bits i done to reduce the pressure?

I showed everything that was needed................

Originally Posted by tui_man2

There i said it.......in the first post

SAME primer
SAME cases
SAME powder
SAME projectile
MORE powder

So where did the excuess pressure go?
Why would i tell everyone the little bits i done to reduce the pressure?

I showed everything that was needed................

I would gueSs it has been forced into and threw the lands before peak pressure rise with the higher load and not with the lower.
But Im just guessing.

Sent from my GT-S5360T using Tapatalk 2