I had a similar problem with 150 eldx in 7mm,
The first round would always go 2-3inches right and the other three would be tight.
I haven't figured it out yet, let me know how you get on please @ edunn
Printable View
I had a similar problem with 150 eldx in 7mm,
The first round would always go 2-3inches right and the other three would be tight.
I haven't figured it out yet, let me know how you get on please @ edunn
Will do mate. Did you end up using the load?Quote:
Originally Posted by muka88
What are the things to trouble shoot there mate? Epoxy bed a potential fix for it?Quote:
Originally Posted by wsm junkie
Yeh, pretty much.Quote:
Originally Posted by Edunn
If you're getting the split groups once the barrel has warmed up a bit also check to see if the barrel is touching the stock anywhere.
I haven't got around to it yet, i will pull the action out of the stock and torque it back down before i continue,
I found the harder i pushed them the smaller the groups where but started to get a tight bolt lift at 42gr of 2206h and put it in the to hard basket,
It is the only bullet i have tried and havnt been able to get sorted.
I have young kids at the moment so i dont have to much time for fine tuning, just went back to my proven loads and haven't had any issues.
Chers
Right, so I didn't do anything to bedding (other than check screws etc were tight). But I did test out a couple of different seating depths. Found that seated out a little bit further the 139 interlocks performed well (below). So need to follow that load up and check consistency. Haven't yet tested those split loads again but will do that in the next couple of weeks.Quote:
Originally Posted by wsm junkie
Attachment 128203
