I've found that my brass is in need of a trim, could any one recommend an entry level but effective trimmer and deburrer setup.
I'm a uni student so the budget is fairly low.
I've found that my brass is in need of a trim, could any one recommend an entry level but effective trimmer and deburrer setup.
I'm a uni student so the budget is fairly low.
If you put it in a bag and post it I will trim it for you if that works.
Is it too long it won't chamber correctly or is it too long from a book dimension only?
The range of what we think and do is limited by what we fail to notice. And because we fail to notice that we fail to notice, there is little we can do to change; until we notice how failing to notice shapes our thoughts and deeds
Lee case length gauge and cutter combo plus a Hornady chamfer/deburr tool - job done
following
The range of what we think and do is limited by what we fail to notice. And because we fail to notice that we fail to notice, there is little we can do to change; until we notice how failing to notice shapes our thoughts and deeds
@MDub
How many cases do you have to trim?
Cheers
Pete
Arguing with an Engineer is like Wrestling a Pig in Mud.
After awhile you realise the Pig loves it.
@MDub this is the perfect solution. Cheap as chips to buy, easy to use - you can sit in front of the TV and do your cases.
I still use mine at times for my less often reloaded cartridges rather than set up my bench mounted one which I prefer to leave set up for my main cartridge.
And regardless of whether your cases need trimming or not you should have a chamfer/deburring tool to tidy up the necks and to allow better starting of the projectile when seating, also to remove any roughness that may mark the projectile.
Bookmarks