If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
right so you keep ONE factory round aside...set up your dies for length/seating depth with it...giving you same or VERY similar bullet jump you are half way there.... velocity will be somewhere between 3/4 and maximum...being a factory loading it wont be super hot and being federal shouldnt be too mild.... you could if you happend to know what powder was used in factory load pull a round and measure it.... or if had chronicgraph fire factory load and keep going with reload till find same velocity...... or just put a not too hot load together and go shoot something.
Federal will be mixing powders to get a 'secret recipe' I would imagine-
Yea going to just work up load to same (or very similar but maybe slightly higher) velocity as you say.
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks