Thread: 7mmSaum Load Ratio in Model 7

Originally Posted by Tikka7mm08

What did you make it from...I have little to no engineering ability... @MSL

Mine's is pretty crude - a piece of straight copper pipe left over from my house build. A funnel cut as required and epoxied to the tube.

The secret then is to tip the powder into the funnel and create a swirling effect like water going down a plug hole. Much more effective than just tipping it into the funnel.

Obviously still need to put your normal funnel on the case unless you can do something smart with the bottom of the tube to fit nicely to the neck but then it will be limited to just one caliber.

Had it for many years and have meant to make a flash harry one but no need.

I seem to end up using the slowest powders for my cartridges so most of them are chocka and need the drop tube.