Has anyone tried the ADI brass , thinking specifically about 223 in a bolt gun.
Has anyone tried the ADI brass , thinking specifically about 223 in a bolt gun.
Quis custodiet ipsos custodes?
Fired quite a bit through my 223 never had any issues with it.
I have heaps. Its my favourite. Cheap, tough, reliable.
loaded lots of 223 for my AR, never an issue
Great stuff chaps , thanks,
I'll order some.
Quis custodiet ipsos custodes?
On more thing I've been reading it's a bit heavier so capacity maybe reduced compared to other brands, has anyone found this?
Quis custodiet ipsos custodes?
I use it in my Ruger 223 bolt action, seems to work fine. One thing I found is that a lot of the cases needed trimming after the first firing, so definitely check your case length. I always check every case on the Lyman E-zee gauge (sp?). All the ADI 223 were okay new, probably more than a third were overlength after first firing, necksized only.
From what load development I have done so far, my loads are a bit below listed max but listed starting loads were safe as a starting point (ADI data using AR2208).
Thanks.
Quis custodiet ipsos custodes?
I'm using it at book max for my AR using CFE 223. So far very happy.
Pic is 5 shots at 100 yds
Sent from my SM-G935F using Tapatalk
Yup, book max for me too using BM2 with 50gr V-Max, and AR2206H with 60gr Nosler BTs. Haven’t had the over length problem mentioned above. Neck sizing only for first 4 loads, then a full-length resize, rinse and repeat.... am up to my 9th loading of this brass now, all good, everything still within spec.
Bookmarks