Thread: Annealing machines?

I think an anything that automates time and rotation in the flame is the go .
Consistency is key or you may as well not bother.

Originally Posted by veitnamcam

I think an anything that automates time and rotation in the flame is the go .
Consistency is key or you may as well not bother.

Im not sure that exact timing is any real advantage. Bit like weighing powder down to the .01 of a grain. If you have the timing within a reasonable range neck tension seems very consistent. I do take them a little hotter than most seem to recommend though. Iv been told that the way I do it wont work but yet i have no problem getting long brass life and very good accuracy and ES with loads. Its cost me nothing to set up aside from a few cases while I was leaning ...The proofs in the pudding so Ill stick with it.