Thread: Blow torch for annealing

Also, I would say the hopper hasn’t saved me anytime yet as I’m still working on getting it 100% reliable so I usually end up watching it anyway to catch the 1 in 50 cases that bounces off or stops halfway down the ramp. I have only done maybe 250cases total so far on it.

Originally Posted by Oli1102

Also, I would say the hopper hasn’t saved me anytime yet as I’m still working on getting it 100% reliable so I usually end up watching it anyway to catch the 1 in 50 cases that bounces off or stops halfway down the ramp. I have only done maybe 250cases total so far on it.

The bit of experimenting I did to see if I can get the synch the second motor is the challenge. And if you anneal more than one type of brass then you have to calibrate the two each time (which just wastes time).

Seeing that the manual feeding works well, it was not a big enough issue to put too much effort into automating it. But auto feeding will be a big plus if you want to anneal a lot of brass at a time.


Sent from my iPhone using Tapatalk