:omg::pissed off: I just trimmed 56x308 brass to 2.05mm when it should have been 2.05 inches so my brass is about .35 inch shorter than it should be
can I still use it or do I dump it??? farken idiot
Printable View
:omg::pissed off: I just trimmed 56x308 brass to 2.05mm when it should have been 2.05 inches so my brass is about .35 inch shorter than it should be
can I still use it or do I dump it??? farken idiot
Not a lot of room for powder in a case that is 2.05 mm long to be fair....:)Quote:
Originally Posted by 57jl
Your numbers don't stack up if you took .35 of an inch of the 308 case it would have no neck...
If your cases are 0.035, 35 thou short they will still be ok in most circumstances
On the bright side they won't need trimming again :D
I have a bunch of cases of various cals trimmed too short. I plan to use them to practice dry firing at some stage when I need to practice at home for a better level of trigger control.
yep 0.035 short sorry
Trim to for.308 is 2.005 not 2.05 so you might not be too short at all?
Im not surprised as your a bit casual with numbers.
All jokes aside, it wont matter a bugger bugger bugger. im sure you will have plenty of neck still