Thread: Bullet seating centricity any tricks and tips?

Originally Posted by andyanimal31

been there done that.
unless your shooting bench rest or elr go and get your ballpeen number and beat your concentricity Guage into little bits.
hornady make a eld seating stem that I use that stops the marking on the projectiles

Sent from my SM-G900I using Tapatalk

Yes your probably right, I'm going to join my local long range so just want to get it a little better than what they are now. Hoping that the Forster die which is optimized for VDL will be a bit more accurate.

Read an article that mentioned that if not central the bullet will head down the barrel slightly deeper on one side in the riffling than the other which is fine until it leaves the barrel then it will tend to move in space put off by its centre of mass asymmetry causing a wider group at the end. Just want to eliminate a bit of this.