Thread: Cleaning mistake

Ive seen good ol' fashioned drink bottles used to replace powder hoppers. Pick one that has an appropriate sized neck, the solid bit with the thread etc and carefully file/sand the thickest piece to to the right diameter. Trim off the excess, cut off the bottom about 30-40 mm up from the bottom. Up end it and seat it. Then use the bottom as a cap.

Originally Posted by Husky1600

Ive seen good ol' fashioned drink bottles used to replace powder hoppers. Pick one that has an appropriate sized neck, the solid bit with the thread etc and carefully file/sand the thickest piece to to the right diameter. Trim off the excess, cut off the bottom about 30-40 mm up from the bottom. Up end it and seat it. Then use the bottom as a cap.

yip that works with the shotgun reloaders.... the one shown is quite a bit fatter and has straight sides...he could get lucky and find small water bottle the right size though......