Thread: different brass for accuracy

Originally Posted by Larskramer

Hey guys,

Is it worth when developing a load to stick to the same brand brass?

Eg for my 7mmrm, I have 58 cases of hornady, about 80 cases of winchester and a few of somthing else.

Is It worth selling off the brand that's in needed?

Brass type will differ in type of brass so your neck tension might vary and you will have difficulty to read the pressure signs as the softer brass might show extractor markings sooner than harder brass. And the case capacity will be different so your pressures wont be consistent so you will have challenges finding your nodes.

Go with one type, and pick the best quality one you can afford. Will save you a lot of pain.


Sent from my iPhone using Tapatalk