Thread: Lee loader kit

Greetings All,
Much in line with the above comments I use them for low pressure loads in my .303 rifles. These cases will likely never need FL sizing although I could do this in an old vice die I have. They size the necks very straight, straighter than many press mounted dies. I do run a .311 expander button in and out of the necks on the press but could probably drop that step. In the interests of science I did seat just one primer with the hammer, wearing a full face shield, but now use a hand primer. Charges are weighed and for convenience projectiles seated in the press but seating in the Lee Loader die is at least as good. For subsonic loads in a .308 together with some scales and a hand primer they should do the job.
Regards Grandpamac.