Thread: Lube Cases?

Originally Posted by zimmer

Neck sizing - Hornady One Shot spray (the aerosol one), Angle spray so that the inside of neck is also lubed. I use a wooden loading block that only has the necks showing. One Shot just loves plastic trays ha ha.
FLSing - Stamp Pad and any of the good liquid lube oils. I use Lyman. Small wipe with same oil on cotton bud inside necks.
Case Forming - There is only 1 lube and I use Imperial Sizing Wax.
Hornady One Shot needs minimal clean up. DON'T BE TEMPTED TO USE IT FOR FLSING.
I keep clear of any water based lubes - snake oil - apart from potential corrosion issues they just don't posses the lubrication qualities of the likes of Imperial.

I have used my first can of one shot and justed cracked the second last night.
I came up with a cunning plan of spraying the neck up in the block from 4 directions but then to get the lube to the bottom where its needed i put another tray on top and flipped it over so they were upside down and sprayed their bums!
Worked a treat and the brass was really smooth through the press so just a bit of lateral thinking has done the trick.
I rate the stuff personally and wilk be putting my third can into stock soon!