Can someone give me the distance from bore to unit for best results. The one I have borrowed has no instructions but has a lot of shims and I don’t want to f@&k it.
@gadgetman I think you have used one before.
Can someone give me the distance from bore to unit for best results. The one I have borrowed has no instructions but has a lot of shims and I don’t want to f@&k it.
@gadgetman I think you have used one before.
I Have Sexdaily. I mean Dyslexia! Fcuk!
Forgot to add that it is going under a DPT suppressor, couldn’t edit.
I Have Sexdaily. I mean Dyslexia! Fcuk!
Theres a square rod spacer in the lid about 7mm below the bottom of the bore.
Instructions are available online
As Brian said. Lay the square rod on top of the pick up sensor and the top of the rod should level with the bottom of the hole in the DPT. Use spacers to adjust until correct.
Sent from my SM-A530F using Tapatalk
This is the link to the Instruction manual if it helps
https://media.mwstatic.com/productdo...structions.pdf
the square spacer rod is in the top foam part near the hinges
Use a lab radar!
PM if you want to borrow mine.
Warm Barrels!
Cheers fullas.
I Have Sexdaily. I mean Dyslexia! Fcuk!
I put a non ferrous rod in the barrel. Gives a better indication with tapered barrels of how straight and the distance.
There are only three types of people in this world. Those that can count, and those that can't!
@Shootm is this the case yours came in ,if so I'll send a pic of the instructions via pm.
I normally just keep a screw together cleaning rod full time in the kit,and use that as a guide ,as that kit doesn't come with plastic square rod which I've seen come with other models .
Sent from my SM-G930U using Tapatalk
![]()
Bookmarks