Thread: Micrometer Bullet Seater for Zero Error Lee Target Loader

Second question of a slow Saturday..

I have the main part of a Lee Micrometer Bullet Seater for the Classic Lee Loader, (whackamole loader). It is part of the Lee Zero Error Target Loader version of the Lee Loader.

It is missing the seating rod assembly (well actually all the other bits of the original kit but its just this bit I need).

I have the Standard Lee Loader kit for 7x57mm and no, the similar part from that kit does not work properly as it does not have sufficient length for the collar to drop over the main tube holding the brass and engage the Micrometer lip to set the depth.

This will be obscure if you are not familiar with the tool.

I am hoping to either find someone with the part who can make a copy or who would allow me to get a copy made. Its a small lathe job.

The photos are from one that was on eBay. The black assembly is what I need plus the silver collar immediately below it.

My Calibre is 7x57mm. Any rifle calibre could likely be used for a pattern but 30 cal or 7mm probably best

Of course if you have one of these sets in any calibre you will let go please PM me

Cheers
J.