Thread: Need help with 6 mmbr over Hamilton

Hi,
I have just finished putting together a 30br.
I have some 6 mmbr lapua cases that I would need to get full length sized.just a dozen of them.
I will do the rest of the neck up and prep for the transformation to 30 br.
I just want to fireform a few to send to the USA to get a custom dies made.

If any body could help that would be great.

Thanks.
Friwi

These.........
REDDING TYPE-S NECK BUSHING DIE SET, CATEGORY I CARTRIDGES | Sinclair Intl mm Rem BR (Benchrest)

Then
REDDING TYPE S DECAPPING ASSEMBLIES | Sinclair Intl

Then
REDDING STANDARD BULLET SEATING MICROMETERS | Sinclair Intl

Job die at tiny cost to custom dies, bore out the body die to fit your 30cal neck
You don't even need the replacement stem if you don't like to expand neck after sizing an with a bushing die its not need anyway since you are not working the shit out of it

I have all the 6BR dies you may need if you are near Tokoroa drop in a use my gear not a problem. Robert.

Originally Posted by tui_man2

These.........
REDDING TYPE-S NECK BUSHING DIE SET, CATEGORY I CARTRIDGES | Sinclair Intl mm Rem BR (Benchrest)

Then
REDDING TYPE S DECAPPING ASSEMBLIES | Sinclair Intl

Then
REDDING STANDARD BULLET SEATING MICROMETERS | Sinclair Intl

Job die at tiny cost to custom dies, bore out the body die to fit your 30cal neck
You don't even need the replacement stem if you don't like to expand neck after sizing an with a bushing die its not need anyway since you are not working the shit out of it

Has to be the easiest way to go. Type S neck die with a 30cal bush, and a new seater stem.

Thanks for your help all.