Thread: New Dillon Press

Well after some time, I finally manged to purchase myself a Dillon 650 press.
I bought the press in 9mm with a case feeder,Strong Mount,Bullet Tray Kit/Strong Mount,Powder Check,Case Gauge,Primer Flip Tray,I have a Dillon Roller Handle & ×4 Pack Primer Pickup Tubes awaiting delivery.
Got a Lyman 1200Pro Tumbler also to get those cases nice n Shiney.
I also bought and installed a Ultimate Shellplate Bearing Kit & Camming Pin Bearing,which also came with Powder Measure Knobs,Low Mass Detent Ball & Clamp/Cam screws.
Have now fastened down to bench & have set up dies/powder thrower.
Done a test run of rounds & have chrony for speed and PF,have since done my first lot of ×2000rnds ...
Setting up press was pretty straight forward & didn't take too long(especially once I decided to consult the instructions lol)
Operating the press is unbelievably smooth.
I'm looking forward to smashing out many many many thousands of rnds off this press