Thread: Projectiles for the 6.5mm

140gr partition?
Done a lot of research for the long awaited 264 win mag project and that one pops up often. 130gr accubond would be my next choice.
@300_BLK did some good writing on projectiles for his 264 and think he was a fan of one of the mono metals like. Barnes or gmx. Only 124gr?
He also did some work with the new at the time sierra gamechangers. Think they did pretty well too

Originally Posted by csmiffy

140gr partition?
Done a lot of research for the long awaited 264 win mag project and that one pops up often. 130gr accubond would be my next choice.
@300_BLK did some good writing on projectiles for his 264 and think he was a fan of one of the mono metals like. Barnes or gmx. Only 124gr?
He also did some work with the new at the time sierra gamechangers. Think they did pretty well too

@grandpamac I have done a lot of experimenting in my 264 Win Mag with 77gr up to 156gr.

Bear in mind the might 264 has a few extra fps when loaded with slow powders that give good case fill.

I have had excellent results with the 140gr Hornady SST which usually passes completely through red stags out to 400m. I found the 130gr Sierra gamechanger (tipped gameking) too hard for my liking, it pencilled through and also found this with the 130gr accubonds. Those are the only two bullets I have not recovered an animal with when using the 264.

Recently I have moved to the 120 gr GMX and Barnes TTSX as my barrel is showing significant wear and will not last long. These bullets are excellent performers at high velocity (2800fps +) but I have observed they have a different impact sound which I attribute to the lack of lead and density of the projectile. The caveat with mono's is that you must drive them hard to work, and they respond well to this in load development also.

I am currently experimenting with the Cutting Edge copper Raptor bullets that weigh 110gr https://cuttingedgebullets.com/6-5mm...d-range-raptor and these are exceptional. They enter and go off like a grenade and the solid shank passes out the other side leaving large blood trails.

In short if you want a traditional bullet:

140gr SST
143gr ELDX
156gr Berger EOL (requires a fast twist)

If you want a monolithic:

120gr CX (New GMX from Hornady)
120gr Barnes
110gr Cu Raptor

Originally Posted by 300_BLK

@grandpamac I have done a lot of experimenting in my 264 Win Mag with 77gr up to 156gr.

Bear in mind the might 264 has a few extra fps when loaded with slow powders that give good case fill.

I have had excellent results with the 140gr Hornady SST which usually passes completely through red stags out to 400m. I found the 130gr Sierra gamechanger (tipped gameking) too hard for my liking, it pencilled through and also found this with the 130gr accubonds. Those are the only two bullets I have not recovered an animal with when using the 264.

Recently I have moved to the 120 gr GMX and Barnes TTSX as my barrel is showing significant wear and will not last long. These bullets are excellent performers at high velocity (2800fps +) but I have observed they have a different impact sound which I attribute to the lack of lead and density of the projectile. The caveat with mono's is that you must drive them hard to work, and they respond well to this in load development also.

I am currently experimenting with the Cutting Edge copper Raptor bullets that weigh 110gr https://cuttingedgebullets.com/6-5mm...d-range-raptor and these are exceptional. They enter and go off like a grenade and the solid shank passes out the other side leaving large blood trails.

In short if you want a traditional bullet:

140gr SST
143gr ELDX
156gr Berger EOL (requires a fast twist)

If you want a monolithic:

120gr CX (New GMX from Hornady)
120gr Barnes
110gr Cu Raptor

Attachment 198360

And 124grn Hammer Hunter. (mono)

A good cheap and available 6.5. bullet is the 140 Speer Gold Dot. Bonded and penetrate well.

[QUOTE=300_BLK;1322993]

In short if you want a traditional bullet:

140gr SST
143gr ELDX
156gr Berger EOL (requires a fast twist)

LMFAO........ how you could call ANY of those three a traditional projectile is beyond me........ correct me if Im wrong but none were around 30 years ago let alone 100 years ago when the 6.5 calibre was in use world wide.....
the hornady interloct in question would just about have to rate as the mosttraditional projectile out there along with speer soft point spitzers etc....traditional to me implies cup n core with exposed lead tip,either round nosed or splitzer

[QUOTE=Micky Duck;1323195]

Originally Posted by 300_BLK

In short if you want a traditional bullet:

140gr SST
143gr ELDX
156gr Berger EOL (requires a fast twist)

LMFAO........ how you could call ANY of those three a traditional projectile is beyond me........ correct me if Im wrong but none were around 30 years ago let alone 100 years ago when the 6.5 calibre was in use world wide.....
the hornady interloct in question would just about have to rate as the mosttraditional projectile out there along with speer soft point spitzers etc....traditional to me implies cup n core with exposed lead tip,either round nosed or splitzer

Great words of wisdom from the Duck

[QUOTE=Micky Duck;1323195]

Originally Posted by 300_BLK

In short if you want a traditional bullet:

140gr SST
143gr ELDX
156gr Berger EOL (requires a fast twist)

LMFAO........ how you could call ANY of those three a traditional projectile is beyond me........ correct me if Im wrong but none were around 30 years ago let alone 100 years ago when the 6.5 calibre was in use world wide.....
the hornady interloct in question would just about have to rate as the mosttraditional projectile out there along with speer soft point spitzers etc....traditional to me implies cup n core with exposed lead tip,either round nosed or splitzer

@Micky Duck I'm sorry my definition of traditional bullet design doesn't fit into your narrow selection of 2 projectiles. When I say 'traditional' I am referring to copper cup, lead core as opposed to mono metal design.

The SST and ELDX are cup and core with a red plastic tip and good marketing behind them.

The EOL has an enclosed lead core with a longer draw on the swaged jacket and then a separate pointing exercise to increase BC.