Have a search here - I put up a link to the base settings I used
If you cant find it - I'll have a dig
I'm not in front of mine so cant tell you exact settings, but what I will tell you is, when they are setup right, you can almost get them to run full bore and stop 0.1 or 0.2gr off and trickle that up in a sec or 2 - using stick powder.
Do you run it with the shield on it or not?
What are you using for a power supply?
Any fluros around?
Just remember to shut the drain chute when you're finished.
Nothing is more funny than pointing and laughing at your mate as new tin of powder pours out the bottom all over your messy shitty bench![]()
Bookmarks