Thread: RCBS Dies... Problem?

Originally Posted by veitnamcam

You are hitting the case holder while on the sizing stroke with a case being sized?!?

First ascertain where the case is stopping you chambering it, if it is at the mouth all good trim, if it is at the shoulder your die needs to go down, die setting instructions are shit....dont set to touch the case holder set to match your rifles chamber lenght/headspace.

If it is tight on the shoulder the die needs to go down, if it is kissing the shell holder WHILE SIZING the case you need to remove some of the die from the bottom.
presses stretch and kissing the holder with no case can be miles of with a case.

I think he can chamber it and the measurements stack up its just tight as on the way out of the die

Originally Posted by Gibo

I think he can chamber it and the measurements stack up its just tight as on the way out of the die

He said excessive resistance closing the bolt.

Sent from my SM-G800Y using Tapatalk

He did, my bad As you were mate ha ha ha