Thread: Reloading Range Brass

so 1 grn of powder = ABOUT a 4% difference...if you using a 25grn load for ease of calculation.....
also for ease of calculation 3000fps velocity x 4% =120fps
which under 250ish yards wont matter a hoot lol.
and if we keep with the 4% figure for arguements sake..as long as we arent hot rodding our loads up past a 95% till too hot in smallest case.... all is good in the hood.

Originally Posted by Micky Duck

so 1 grn of powder = ABOUT a 4% difference...if you using a 25grn load for ease of calculation.....
also for ease of calculation 3000fps velocity x 4% =120fps
which under 250ish yards wont matter a hoot lol.
and if we keep with the 4% figure for arguements sake..as long as we arent hot rodding our loads up past a 95% till too hot in smallest case.... all is good in the hood.

Greetings, @Micky Duck,
I grain of powder was the difference between Federal and Winchester with an additional grain for the Continental brass. Will do some chronographing over the next week or two and report.
Regards Grandpamac.

Originally Posted by Micky Duck

so 1 grn of powder = ABOUT a 4% difference...if you using a 25grn load for ease of calculation.....
also for ease of calculation 3000fps velocity x 4% =120fps
which under 250ish yards wont matter a hoot lol.
and if we keep with the 4% figure for arguements sake..as long as we arent hot rodding our loads up past a 95% till too hot in smallest case.... all is good in the hood.

Great, thanks for that.