Thread: strelok ballistic app

Originally Posted by septic

pull the bolt out to a distance equal to the end of the scope and then use a rule to measure roughly centre of bolt to centre of scope

Or use a vernier caliper, measure barrel outside diameter below scope objective lens, measure scope objective diameter and then measure the gap between scope and barrel.

gap + half objective + half barrel diameter = scope height. Geeked out pretty hard on that but the number is very accurate.

Originally Posted by MGNZ

Or use a vernier caliper, measure barrel outside diameter below scope objective lens, measure scope objective diameter and then measure the gap between scope and barrel.

gap + half objective + half barrel diameter = scope height. Geeked out pretty hard on that but the number is very accurate.

So take stock off to do this?

Originally Posted by Gibo

So take stock off to do this?

You could measure the bolt diameter instead of barrel diameter, since they share the same centerline.

Sent from my SM-T800 using Tapatalk