Thread: Tight cases after putting through the die

Recently got a 270WSM, brought some new Norma brass & some Hornady dies - not my fav dies as their sizing die set up is cheap n shit looking, but was all I could get & I don't mind the seating set up.

Problem I have is I go to size my "once fired" brass ( which chambers fine ) run through the fL die it becomes so hard to chamber, I have taken the expander out & tried multiple depths, makes no difference even just backing off with half the neck sized it still is tight to load, while my reloading is very agricultural I've never had this issue before

Any ideas on whats causing this ?


Cheers