Thread: Type S Bushing dies

Originally Posted by Puffin

Having now replaced all of my Redding Type-S bushing dies with Competition bushing dies, maybe consider these over the Type-S if you are going to the expense of changing to some type of bushing die. The Type-S wouldn't size concentrically in my set-up, and it is just possible you may end up with a similar issue. Most reloaders don't seem to have a problem with them however. Accurate Arms & Ammo have been good to deal with for getting Redding gear from the States.

I've found with the Redding neck sizing bushing dies that concentricity improves a lot by just backing off the amount of sizing on the neck by using the top adjustment screw.

If I ever get any cases with run-out greater than .002 I use a RCBS bullet puller with the correct sized collet by hand to just bend the bullet back into line. Doesn't take much.