Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Gunworks Terminator


User Tag List

+ Reply to Thread
Results 1 to 15 of 53
Like Tree42Likes

Thread: 6.5 grendel

Hybrid View

  1. #1
    Member
    Join Date
    Aug 2012
    Location
    helensville nz
    Posts
    4,707
    Feeding is good mate
    I haven’t tried full mag length as the Sierra hp as quite a stubby nose and contacts the lans well before mag length
    I have some 100gn amax but haven’t tried them yet

    The trigger is crisp and nice out of the box at arround 3lb lightest setting
    Just a little heavy for me I like 1.5-2lb

    Me and @northdude done the trigger job I found on YouTube just cut the trigger waight spring down a little
    Doesn’t affect the crisp trigger just a bit lighter got it pulling between 1.5 and 2 lb like I like

  2. #2
    Member
    Join Date
    Feb 2018
    Location
    Foothills of Appalachian Mountains
    Posts
    2
    I built a pair of 6.5 Grendel's in AR 15 chassis a good time back and discovered it didn't have the gas to do what I wanted. For long shots a 5.56 Wylde chamber was much more efficient and accurate and shorter ranges the 6.8 spc II hits like a freight train. Have two friends that have taken Rocky Mountain elk with 14.7" 6.8 carbines and both were one shot "Dead Right There" kills with massive wounds. I have a fleet of 7mm bolt rifles including 7mm-08. I would think if someone already owns a 7mm-08 were to build a 6.5 Grendel with objective to extend effective hunting range might be working backwards. If went with 6.5 Credmore then you would likely extend range but it's not going to fit in a compact action.

    Reloading does open up options with 7mm-08 but if new to reloading there will be a good bit of equipment and learning curve to overcome. Here on my side of the planet we have some fine factory loaded 7mm-08 options. Currently there is a new 6.5 cartridge picking up a following in the U.S. for compact chassis bolt rifles and AR 15's. It's basically a 6.8 spc II case just necked down to 6.5 with neck trimmed to allow bullet to be seated out to full length in AR 15 magazines or short action bolt rifles. Also another cartridge based on the 6.8 requires some work and custom die set but necking the 6.8 down to 6mm and it has some reach with 100 to 115 grain bullets.

    You mentioned putting your money into better glass for your 7mm-08, combine that with some trigger tuning along with having a smith make sure rifle is bedded properly a 7mm-08 should hold its on at 1,000 meters for paper punching and would be a relatively easy reach for deer out to 600 meters. Have quite a few custom turn bolts from 22 Hornet to 338 Lapua magnum but my 7mm's are most used due to versatility due to bullets with high ballistic coefficient and the mass to deliver significant tissue damage if properly chosen for velocity expected at a given range. Have 7mm-08, 7mm Rem Mag, 7mm RUM and 7mm Practical. Till broke my neck was a big fan of 7mm Practical, 300 Win Mag and 338 Lapua. Since broke the C2 and C3 vertebrae have had to adapt in order to sit at the bench all day testing loads and practicing my marksmanship. Cartridges like 6.8 spc II in short actions have 80% of the energy of a 308 out to 250 meters and very manageable recoil. Have become a huge fan of the 6XC for 1,000 meter paper punching as can send 115 grain 6mm bullets out to extreme distances with almost no recoil compared to most long range cartridges though would only use for smaller game in hunting situation.

    The recommendation of many to work with your existing rifle is very sound. You mentioned a 2,500 budget and not sure how your currency stacks against U.S. dollar but recently set up a Tikka in 6.5 Creedmore with a Vortex 5-25x 50mm objective first focal plane scope (Viper PST) and a SIG suppressor for $2,500 U.S.D. and out of the box with only work was lapping the scope rings and adjusting trigger have been taking varmints to deer out to 600 meters with relative ease. Would not have attempted such shots with 6.5 Grendel on anything bigger than a coyote. The Creedmore's longer action allows higher B.C. bullets at higher velocities with less time in flight to target thus much less wind drift and drop. Both of my 6.5 Grendel builds pulled barrels and sold after shooting less than 100 rounds through each as didn't give me a real advantage over other short action cartridges already owned. Jury is still out on the new 6.5 based on the 6.8 called 6.5 SOCOM but seem to be shooting well out to 800 meters with 100 grain bullets. Not seen any animals so with it at extended ranges but varmint season is coming up fast in the southeastern U.S.
    keenbloke, viper, rossi.45 and 1 others like this.

 

 

Similar Threads

  1. 6.5 grendel
    By rambo-6mmrem in forum Firearms, Optics and Accessories
    Replies: 34
    Last Post: 15-02-2017, 05:32 PM
  2. Grendel
    By steven in forum Reloading and Ballistics
    Replies: 26
    Last Post: 11-11-2015, 11:18 PM
  3. Anyone playing with 6.5 Grendel
    By specweapon in forum Firearms, Optics and Accessories
    Replies: 4
    Last Post: 29-07-2014, 07:09 PM
  4. 6.5 Grendel Ammunition
    By gimp in forum Firearms, Optics and Accessories
    Replies: 24
    Last Post: 10-05-2013, 01:50 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!