If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
its a squeeze at 82mm you have to mill the front an rear a fair bit an to get the bullet to unload if unfirerd is a pain have to pull it back then push it forward again an there not much left of the bolt stop but it can go that long.
doing a 7mm wsm at moment that will have long throat for the 180gr so will post photos of the build where is milled etc
Look forward to the thread... Be a while before I am ready. Got to finish other gear first
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks