Thread: believe it or not?

Originally Posted by sneeze

. The problem with verifying this is identifying max pressure with either powder. While someone may appear to get some velocity back its most likely they are just running at a higher pressure. Or didnt have the best powder to begin with

Originally Posted by sneeze

No debate about velocity and barrel length. The longer the barrel the longer the bullet is exposed to the pressure so the longer it will keep accelerating.
the discussion is really about optimum burn rate and barrel length.

Both good points.

If you think of a pistol length barrel at one extreme and a 30 inch in something a bit over bore like 243AI with 105s requiring a slower powder like N165 or whatever.

With the slow powder in lets say a 4" barrel with the same load as the optimum 30'', that optimum powder for the long barell may not even reach peak pressure until the projectile is 6" down the bore.(a figure plucked out of my arse)

So in this made up situation, faster powder would almost certainly yield more velocity for the same peak pressure in the 4'' barrel but still be a long way short of 30'' velocity.

The best speed will always be from whatever powder has the highest average pressure for the projectiles full travel of the bore while staying under max pressure.

What is max? Well that is entirely up to the individual re loader but with the same components other than powder a reasonable comparison should be able to be made( 1 pound vs 6pound hammer to open bolt)

So If you are already getting the best velocity possible from "X" length and whack 6 inches of the barrel faster powder will not get back your velocity,but it may minimize your losses.