Printable View
Hey guys my scope arrived today and mounted as I could'nt keep them apart any longer.
I noticed what I think is the nitrogen gas port or just beside it there is a cap protruding on a 45 degree angle, one side flush the other raised.
Is this normal or a reason for concern? Attachment 20842Attachment 20843
Sent from my SM-T210 using Tapatalk
EK9132
Check out this Viseo the scope mounted on the .22 rim fire shows a similar screw at about 1:49
http://www.youtube.com/watch?v=n5aeNOqpVbw
Cheers
Pete
I have the same scope (and mount) and the same little protruding screw... I have seen it on this range f scopes so its definately factory...
What its purpose is i dont know, a similar bushnell scope has a rubber cap in exactly the same place and angle and its the purge point, so i think you are correct...
Grant
Magic thank you both for replying have only just noticed you can see it on the box! My fault.Off to zero tomorrow so will snap a pic of the target and chuck it up in here for anyone else looking to buy one of these scopes. $229 from reloaders was a bloody bargain.
Dan.
Sent from my SM-T210 using Tapatalk
Let us know how you get on with zeroing it, i have yet to put mine on, with luck this weekend or next...
Thanks Grant
Looks like a good enough scope for an AR.
Just need to get an AR to put one on.
Cheers
Pete
Bugga the Zeroing ... Bring on the Mosin !!!!!!!!!Quote:
Originally Posted by EK9132
:ka boom:
Haha have got a busy night on the range have some loads to test for the AR and Howa then flamethrower action with the Mosin carbine :-) looking forward to it Sean.
Sent from my SM-T210 using Tapatalk
