Thread: Factory Rifle Bedding jobs

G'Day R93,

Yes that is how you should bed any rifle action where the front action screw, threads into the action body!
With actions like Mauser, Brno/CZ, older Sako and Howa type centerfire actions, where the front action screw threads into the bottom of the recoil lug.
The bottom of the recoil lug needs the make full contact, with the bedding at the bottom of the recoil lug recess!

Given this and the above images, my Win Mod 70 7mm Rem Mag rifle, consistently shoots 1/2" to 5/8" groups!!!
R93, I wonder how much the rubbery like flexible nature of the Winchester (and Browning) bedding material, has to do with this???

Doh!
Homer

Good point on anchored recoil bars. Not sure on the rubbery stuff. Just typical factory cost cutting IMHO, but if it usually works..........Some old 77 Poo-gurs are a pain to bed.
I like simple two contact type actions with out having to worry about tang lift etc.

G'Day R93,
You and me both, on All counts!!!

When I get a chance, I will post a photographic "How To" bed a rifle on this forum.
I have taken most of the images, just need to get a basic plan of approach in place.

Further to bedding a Win Mod 70's.....
Whilst I tighten the front and rear screw firmly, I actually place a small amount of Loctite 222 on the threaded portion of the middle screw, then tighten this screw until it is just barely tight, then back it off from 1/4 to 1/2 a turn!
This keeps every thing in place but stops the middle screw from bending the action and effecting the bedding!
Works for me!!!

Doh!
Homer

Sh*t; I better check mine...

What has this got to do with a hunting story ?????