Has anyone fitted flush cups to a Sako carbon light stock?
Sent from my CPH2145 using Tapatalk
Printable View
Has anyone fitted flush cups to a Sako carbon light stock?
Sent from my CPH2145 using Tapatalk
Not a carbon light but I fitted some to my fierce fury which has a carbon fibre stock. So long as you make a cone under the outer layer of the composite skin for the epoxy to fill in and create a wedge is the main thing. I imagine the carbon light stock would be formed around a blank in the same way.
Whatever you drill the hole with, it'll need to be spinning fast to make a neat cut on the carbon fibres, as slow will just tear them & leave a ragged hole. On a mill would be best.
My last one had one https://uploads.tapatalk-cdn.com/202...cf8c49871d.jpg
Sent from my iPhone using Tapatalk
Was that the one after the other 3 [emoji848]Quote:
Originally Posted by buzzman
Sent from my CPH2145 using Tapatalk
Haha yip number 7 I think[emoji23]Quote:
Originally Posted by 25/08 IMP
Sent from my iPhone using Tapatalk
I have put the Spartan bipod sockets into about 5 carbon stock and as Mathias as said fast drill speed is key.
I used a drill press at 3000rpm and a sharp forstner bit which cuts a nice clean hole. Go slow and let the bit do the cutting.