Jw105, bolt parts

Gidday. Just been dropped of a the above firearm to see if I can get what's needed to get the bolt/ rifle functioning again.
There's definitly an extractor missing and there another slot with out any thing init to.
Any tips for getting sorted.
It's a .556
Cheers Andyhttps://uploads.tapatalk-cdn.com/202...e402decb58.jpghttps://uploads.tapatalk-cdn.com/202...7499917b26.jpg

Sent from my SM-A226B using Tapatalk

Are the JW105 extractors the same as the JW103?

Quote:

---

Originally Posted by Tommy

Are the JW105 extractors the same as the JW103?

---

I have know idea and not much about on the net either

Sent from my SM-A226B using Tapatalk

someone was filing up to make new extractor from bit of car spring some time back..so it can be done if you have patience...funny feeling the other groove is empty??? @Finnwolf may be good fella and take photos of his one for you or @kotuku

The left hand side groove should have a blade ejector thingy that rides in it on the left side of the action which incorporates the bolt stop and bolt release, the other side has four parts (retaining pin, coil spring, tension rod and extractor claw).

http://www.norconia.de/w/wp-content/...E-DRAWING3.pdf

Quote:

---

Originally Posted by No.3

The left hand side groove should have a blade ejector thingy that rides in it on the left side of the action which incorporates the bolt stop and bolt release, the other side has four parts (retaining pin, coil spring, tension rod and extractor claw).

http://www.norconia.de/w/wp-content/...E-DRAWING3.pdf

---

Alright, it's becoming clear!
3 bits to get the extractor back together!
Anyone got any clues on getting parts.
I'm thinking gun shitty but any other ideas taken on board!


Sent from my SM-A226B using Tapatalk

as said earlier..there was bloke filing extractors from scratch....actually think one of forum gunsmiths did do a few at one stage too??