Printable View
Gidday Folks- a Mauser M18 in 308 has just joined the rack.
On its initial strip down I noticed the front action screw (which is a reversed arrangement from normal) wasn't "tight" to the reciever - it can be turned by hand, is this normal?. It looks like the barrel may have been off this rifle at some point and I wonder if it was reassembled correctly.
Thanks
Wasn't loose on mine.
Sent from my SM-G780G using Tapatalk
The action screw has flats that engage a slot in the stock so it doesn't turn when the action nut is tightened but it's still kinda unsettling
Are you refering to the front block in the stock. I can take mine apart on thursday potentially. But im pretty sure i torqued it up a little while back.
Sent from my SM-G780G using Tapatalk
Drop Mauser a line and ask. Info@mauser.com
They are pretty good at responding. I asked them the correct torque settings for the action screws on my M18 and they stated 5 nm was what they use.
Done. ThanksQuote:
Originally Posted by Krameranzac
@Tentman
What did they have to say?
Nothing. They must have sent my query to the NZ agents, who wrote me a very defensive message saying it wasn't a warranty issue, I tried to engage them by pointing out I wasn't making any claim but they didn't reply. Pretty poor. I dont think they even recognized what I was talking about.