If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed.
Aye, you'll need to check if it's a three or four hole receiver.
Mine is a three hole, only managed to find EGW who made a 20MOA 3hole picatinny rail.
Special order from the USA, bit of a pain but got it eventually. Had to epoxy bed for full receiver contact, but all good since.
EGW is cut properly and allows you to load the internal mag easily, does not foul ejection in any way, however it does sit higher as a result.
I'd recommend that anyone loading a flooplate should learn to load it from the bottom. You can top up the mag with the bolt closed which is a huge advantage IMHO.
See above
Does one of the rear two holes of a four hole M7 pic rail not line up with the single hole in the rear on a 3 hole action? Ie just mount the 4 hole rail with 3 screws?
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
Bookmarks