Thread: New 3D prineted can for the 338LM

You would need only one brake , the only other thing I can think of , is by using the hard steel AI brake , you are using a high grade steel used to make the AI brake , as the 1st two baffles , ie the important blast baffle and the 2 nd baffle , if that makes any sense , this takes some of the pressure off the suppressor its self .

I will need to buy 2 more AI Tac brakes so that all my AI rifles can run the ODL cans .


YES , a high grade of Ti , and then they under go a heat treatment phase as well , before being finished & shipped to buyer .