Printable View
hey all i have a .22 with a nikko Stirling scope on ot and i pulled it out this mornign to do a regular rust inspection and took a look through the scope to find this:
Attachment 201566
is there a way to fix this either at home or getting a gun dealer to fix it. or is it just best to take it off and put the old iron sights that i have for it on.
cheers
lol.have seen that a few times over the years...you can still use it.....but yeah a basic 4x32 will cost you between $60-120 new for similar scope..... irons are good with young eyes....in last 12mths Im finding not so good for me anymore.
If it worries you, why not fix it?
That wee screw bottom right in photo...probably a couple more round there to hold in that wee metal ring that then holds the wire reticle (well my old Bushnell Banner 4x had that system).
I wound off the eyepiece to get to the 3 wee screws, removed them and the wee ring fell out into my hand (the screws had become loose and the reticle retaining ring was bouncing all over the place). Wee dab of Loctite on each screw and refitted and all was well again. Simply wound on the eyepiece again...no problems.
So maybe you can remove the reticle retaining ring and put a tiny dot of superglue (or a wee dab of solder) into the centre of the cross hairs to make that reticle complete again?
My Banner went for years more on my .257, out in all sorts of weather, and never fogged up.
The internal elements sit in wee tubes that are gas filled, but you aren't going to affect them.
Why not? You have nothing to lose. It's a good learning experience.
Check the warranty. Years ago my Nikko Sterling had a lifetime warranty. Took it back to shop after it fogged up and they replaced it without question.
