Thread: Oceania Defence suppressors

Currently 675 inclusive. This is likely to go up before the next batch though. I have one standing by if you want it. Just ring or email.

Here is an update on the new AR10 can.

Weight 225 grams
OAL 215
Length past muzzle - 158
OD 38
Length from shoulder to aft surface - 38
5/8-24 thread
Diameter of over barrel section -19.35

One blast baffle
One end baffle
Seven intermediate baffles
Exit aperture - 10mm

They should be ready for testing next week along with a new batch of the 556-45 Samson.

Hi - do you have a price on this yet?
Cheers

Originally Posted by ODL

Here is an update on the new AR10 can.

Weight 225 grams
OAL 215
Length past muzzle - 158
OD 38
Length from shoulder to aft surface - 38
5/8-24 thread
Diameter of over barrel section -19.35

One blast baffle
One end baffle
Seven intermediate baffles
Exit aperture - 10mm

They should be ready for testing next week along with a new batch of the 556-45 Samson.

Originally Posted by ODL

Here is an update on the new AR10 can.

Weight 225 grams
OAL 215
Length past muzzle - 158
OD 38
Length from shoulder to aft surface - 38
5/8-24 thread
Diameter of over barrel section -19.35

One blast baffle
One end baffle
Seven intermediate baffles
Exit aperture - 10mm

They should be ready for testing next week along with a new batch of the 556-45 Samson.

Hi ODL, How's the 308 suppressor testing going on? and a time line for production?.

Sorry for the delay in responding.

Summary of the sound test on a 16" DPMS 308 was 141.3 at the muzzle and 143.4 at the ear with R1M1 SA ammo shooting 2484 FPS. Without a can (bare barrel) the muzzle sound was 167.2. The same can on a 20" bolt gun was 141.5 Muz and 128.5 Ear. So close to target, but not there yet. The at ear level could be brought down with adjustment of the gas block. It was not changed or adjusted for this test.

I am printing a new test can with several mods. If I can get a short 308 to 140 or less at the ear and muzzle with this size can I am calling it good. Then I will print a batch of both the AR10 and AR15 cans for stock.

Sorry Chris, I will not be doing any custom design work for a year as I have too many other designs to finish. Namely the QD and a new 338 thread on for an overseas customer. I have to say that reviewing your info did make me think of new ways of looking at design and while my changes are far different than what was done in the past, rethinking about design concepts helped me (will know how much at the end of the week) with some things that have not been done yet, so thanks again for the copies.