Printable View
Hi folks,
I've inherited a Peloi scope. I'm hoping someone on here can give me some guidance before I use up piles of ammo, only to find out what you folks already know.
How many inches (or whatever) does each line represent on the reticle?
Cheers
Brad
Personally I wouldn't bother with it.
I saw many Peloi scopes trying to be sighted in at our range (the agent was local) and none of them kept zero, also most had huge POI change as the magnification changed - I'm sure someone will chime in now about how they are the best scope out!
If you want a cheap good scope look at nikko stirling Ive got a herd of them
How much did this pression tool cost just out of intrest?
It would pay to stick with the tried and true brands and always remember, you get what you pay for.
Some times its a hard lesson learned, I hope it didn't cost too much.
I inherited it, so no cost involved.Quote:
Originally Posted by 7mm Rem Mag
To be honest never purchased one but have seen a few on rifles brought to me when the owner need help after initial attempt to zero proved unsuccessful. Using a collimator type bore sighter I noted massive point of the no act shift as magnification power was wound up and down on some of them, so I had no success trying to zero them either. Tried a couple different on rifles of known accuracy and had just as poor results as the guns they came on, I’m sure some one will say they have one and it’s great, but it’s purely a quality control or design issue and they seem to have a fairly high failure rate. My advice would be test or use it on something that uses cheap ammo rather than expensive stuff to find out if it’s any good run a test once zeroed to see if the point of impact changes when u run the zoom up or down it’s not the end of the world if it does you may just have to pick a favourite magnification setting and leave it on that.
They amazing 2 for 1 scopes
I'll say best ever scope
U get multiple points of impact for different zooms , so u don't have to aim off just change magnification for different ranges
M8 piss it off I've seen 2 from clients in about 30 yrs of being a dealer, couldn't getveither to hold or zero between magnifications
The cheapest thrasco or even GC jobs is better