Thread: Pimped 260

...

Is that coarse file or rasp marks on the port and bolt handle cutouts? Would have been nice to see that finished off a bit better.

These stocks look pretty good out of the mold but i have seen some pretty rough inletting and finishing on them and a few other nz made stocks, some real shockers actually. For a thousand bucks i would expect better. Don't want to poo on your post but if you want ooh and ahh responses then showing close ups of glaring flaws dont help. Looks like the metalwork is sitting up too far out of the stock by at least 4mm. Hopefully everything lines up properly inside with the bedding otherwise you could have problems there.