Hi all. If anyone has one of the above shotguns, could you do me a huge favour and take a couple of measurements of the extractor it so I can make a 3d model? Attachment 266647
Printable View
Hi all. If anyone has one of the above shotguns, could you do me a huge favour and take a couple of measurements of the extractor it so I can make a 3d model? Attachment 266647
Even just a couple of overal dimensions would probably allow me to scale it from there.
Sure thing, is there any other bits from the action you want measured while I’m in there ?Quote:
Originally Posted by tommygun
I have a parts one here so can pull anything for measurements.
They are not the same !
The 870 and 1100 could be but the 11-87 were beefed up.
Funny thing is while Big Green were using up parts or trying to stay afloat they sold 11-87 with the smaller 870 extractor and that was the only thing that stopped my gun in thousands of rounds.
From memory the part only cost around $20 but i needed a gunsmith to open up the bolt
Volquartsen do aftermarket versions and have agent in NZ?
Correct, the later 1100s, 870, and 11-87 are thicker than the earlier 1100s, I think it's like 3.1mm vs 3.9mm or something. However, they have the same 2d dimensions.
I have actually acquired an extractor and have made a 3d model now. Will see how much it's going to cost to make 10 or so.
