Thread: Ruger PC Carbine review

I know where there is one but it won't be there for long

Sent from my SM-G965F using Tapatalk

h&f has them picked up one from dunedin last week.Two more coming in stock soon.Seems accurate enough three round same hole group at 25m.

It's a cool little rig, barrel swap outs would be nice. If other stock options are available in the future - something abit more 'cooler' looking, I'd be keen.

$1250, i have plenty, and more coming.
if your keen gimme a ring, 0279182760
cheers

Greg

Originally Posted by greghud

$1250, i have plenty, and more coming.
if your keen gimme a ring, 0279182760
cheers

Greg

I found the trigger heavy on mine are they adjustable or after market triggers available yet?

Where is your shop located @greghud?

Originally Posted by Sasquatch

Where is your shop located @greghud?

Custom Guns
127 Yarrow st
Invercargill

Originally Posted by Markgibsonr25

I found the trigger heavy on mine are they adjustable or after market triggers available yet?

take it to your local gunsmith, i am sure they will be able to help

ruger triggers are always heavy from the factory

I would have liked them to put a better thread on it ,1/2 inche is very thin for a 9mm , 5/8 would have been much better , 1/2 inche is a stupid legacy from the 9mm Colt carbine , flash hider .

That can easily be sorted out with a good lathe ;-)

I think the barrel fluting with limit that

As long as I have 12 mm of plein barrel ahead of the fluting it should not be an issue.

fluting is machinable if that's the problem. If I really wanted it done and still required a larger unfluted surface to do the suppressor up against, i'd thread the section of barrel a little longer and make a machined threaded washer to screw onto it.

Originally Posted by Markgibsonr25

I found the trigger heavy on mine are they adjustable or after market triggers available yet?

I think they fit standard 10/22 triggers