Thread: Sako Finnfire II Ring Mounts

Here is the mount height for my sportsmatch rings.
This is a 3-12x44 scope (Hawke Vantage).
I needed the low rings LT031C. Their spec is for 32mm objective but as you can see they are just right for this action and barrel. I did get the higher ones first but the scope was unnecessarily high and I spent the extra money to buy these low ones a few days later. For .22 shooting you really want it as low as possible because many shots are taken at short ranges and you don't want the bullet to start any further below the sight line than absolutely necessary. Also, this stock has a low cheekpiece and I get only a rudimentary cheek weld. The finnfire has a specially low bolt lift so there's no problem clearing the ocular end of the scope. I've got a sako base and ring setup on my 85SS and it's much higher and heavier than needed. Go for a low one piece ringmount.



Here it is from above. There are two screws attaching it to the rail and two each side on the rings. The rings are rated for airgun shooting.



This is the packaging showing the part number.



I'm not sure where else you can get them but I phoned up and ordered mine from Youngs Airguns