Hi all, Looking at upgrading to a ATACR 4-16x42 F1 on my Sako 75, what 34mm rings you guys using and height would fit for this scope?
Printable View
Hi all, Looking at upgrading to a ATACR 4-16x42 F1 on my Sako 75, what 34mm rings you guys using and height would fit for this scope?
Rail?
Sako optilock rings and bases, or, if you've had a rail fitted, take your pick
B
Near rail and then your pick of rings
If ya hoping to get something decent through Beretta NZ ya fuked, I didn't want to use a rail on my 6-204 T3 ( because it looked friggen ugly ) & the only 34mm rings & bases they could supply were extra extra high, ugly useless & way over priced.
I ended up getting some Leupy bases ( still higher than they need to be ) & leupy 34mm rings off KiwiGreg & they were better value & quite tidy.
I'm not using em at the mo so could be keen on selling but not sure if T3 will fit a S75's ?
These guys make a pressure (tap on rail) fits the dovetails of the sako's awesomely made and last one i ordered was here in a week...
Near Manufacturing
I now have rails on all 3 of my sakos. A near rail and two waitaki engineering rails. https://uploads.tapatalk-cdn.com/201...4b189a72f7.jpghttps://uploads.tapatalk-cdn.com/201...59d9b18504.jpghttps://uploads.tapatalk-cdn.com/201...875fbcb0d1.jpg
Sent from my SM-G935F using Tapatalk
What are the better of the two?Quote:
Originally Posted by josh86
Both good. For cost I would go waitaki and also dose a really good job.
Sent from my SM-G935F using Tapatalk
Gun city was/is selling a 2 piece picatinny rail which slides onto sako dovetail,, made by Tier One.
EAW aqlso make a slide on mount for sako 75/85 https://www.optics-trade.eu/nz/mount...-75-34-mm.html
From an engineering perspective the NEAR rail hands down. Lower and fits into the dovetails with an integral recoil lug. No drilling and tapping.Quote:
Originally Posted by tikka
I've had both.
B
Thanks for all the input guys.