Thread: Sauer Ceratec - experience?

Originally Posted by Tahr

Howas do that too. Mates did it on last wallaby hunt. Used the truck draw bar edge to lever it back around.

This is a little different on the sauers. when the bolt rolls over the wrong way the sear ends up in the bolt stop groove on the bolt and can not be remedied without removing the trigger assembly from the action

Originally Posted by sdogg73

This is a little different on the sauers. when the bolt rolls over the wrong way the sear ends up in the bolt stop groove on the bolt and can not be remedied without removing the trigger assembly from the action

Ouch. I wonder if the M18 are the same?

Iv seen other brands do that but never in the rifle. Turning like the bolts closing (handle going clockwise looking at the tang end) cocking the bolt as such just not in the rifle . That’s gone anti clockwise in the rifle wtf try it @Tahr and let us no eh

Originally Posted by Kelton

Iv seen other brands do that but never in the rifle. Turning like the bolts closing (handle going clockwise looking at the tang end) cocking the bolt as such just not in the rifle . That’s gone anti clockwise in the rifle wtf try it @Tahr and let us no eh

Ha. Im not going to tempt fate. I will have a close look at it though.

I tripped my bolt in my hands the other day so don’t look to closely mate accidents happen felt like a right fool

At least a third of those sauers imported had their cerakoting peel off.