Thread: Scope dialling check

Don't shoot anything. Clamp scope/rifle so that it is zeroed on the centre. Then dial and see how it actually moves, say 5MOA windage and 10 MOA elevation. 10MOA should be 10.47 inches at 100 yds.
It is probably the wind/terrain doing something funny rather than the scope, especially if it has worked well before.

Originally Posted by stug

Don't shoot anything. Clamp scope/rifle so that it is zeroed on the centre. Then dial and see how it actually moves, say 5MOA windage and 10 MOA elevation. 10MOA should be 10.47 inches at 100 yds.
It is probably the wind/terrain doing something funny rather than the scope, especially if it has worked well before.

Would do but as mentioned no clamp

Originally Posted by Gibo

Would do but as mentioned no clamp

Gibo go down to bunnings or mitre 10 and get yourself a couple of g clamps.
The you'll be set, don't worry about the marks it will leave

Sent from my GT-I9300 using Tapatalk