Thread: seized suppressor

Originally Posted by Boaraxa

Iv never used one before , so do u pull the suppressor to bits & clean that as well after use ? presuming once the barrel has had a patch through it suppressor can go back on even in storage ? Are the A-Tec suppressors any good ?

Powder residue is hygroscopic.

From the DPT instructions:
During shooting condensation is created inside the suppressor, containing amongst others ammonia (mixture of burnt powder and water). Failure to remove the suppressor within a reasonable period of time after shooting will cause rust to form in the gun barrel. It is therefore practical to unscrew the suppressor after shooting on a range before packing the firearm for transport. When hunting the suppressor must be removed after the end of the hunt. Store the suppressor so that air can flow freely through it and dry it out, if suppressor is put away wet a white powdery build-up may occur on the baffles, in this case just wipe it off and wipe thin oil over the baffles. When the suppressor is dry it is advantageous to spray a little oil (aerosol) into the suppressor. In short, treat the suppressor as you would treat your rifle.