Thread: T3 bottom metal

Hi there,

has anyone finally sourced or produced T3 bottom metal to accommodate standard mags yet?

thanks

CDI do an AICS one.

Originally Posted by rogers.270

Hi there,

has anyone finally sourced or produced T3 bottom metal to accommodate standard mags yet?

thanks

Hi Morgan,

Are you after bottom metal for STD T3 mags or another type of mag? (AICS)



AluTek STD T3 bottom metal - alloy - very nice!! (Have one on my Battue if you want to check it out)
$350.00 + Freight etc



AluTek T3 AICS bottom metal - non tactical mag release - also very nice.
$550.00 + Freight etc (+ Mags)

What cal are you using? The AICS is short action only. I think CDI do a long action AICS setup?

Atlasworxs also do a SA AICS bottom metal for $165.00 AUD

Home Page

I have two Tikka T3's with CDI bottom metal.
308 & 300wm
A little inlet milling is required, did it to a standard Tikka stock but didn't like what was left so purchased a Bell & Carson stock and milled that, much better. I was pretty happy with the first BC stock so bought another one and did the same modification.

Both can handle 10 rnd AICS mags.
Not a cheap exercise, $600 for a stock and approx $500 for bottom metal & mags. But worth it in my opinion.

This might suit

BELL & CARLSON/CDI&ACI COMBO | Trade Me