Thread: Talley rings on a Tikka

I'm going to try medium talleys with a 40mm objective to see if I get less suppressor in the sight picture.

Originally Posted by Longrun

I'm going to try medium talleys with a 40mm objective to see if I get less suppressor in the sight picture.

Got to be careful with that as it will end up to abit high and trying to get a proper check weld will be abit of a prick and depending on the scope and the magnification range lower mags it wont make bugger all difference having it 4-6mm higher

I have a athlon 2-12 on my bergara 308 and at 2x i have the suppressor in the sight picture but its no issue have to go up to 4-5x to get no suppressor in sight picture

Originally Posted by Carbine

Got to be careful with that as it will end up to abit high and trying to get a proper check weld will be abit of a prick and depending on the scope and the magnification range lower mags it wont make bugger all difference having it 4-6mm higher

I have a athlon 2-12 on my bergara 308 and at 2x i have the suppressor in the sight picture but its no issue have to go up to 4-5x to get no suppressor in sight picture

Yeah, we'll see. It's only a few mm difference

Get some plasticene, make 2 blobs and place on top of receiver then put your scope on top and squeeze down so still got 2mm of clearance for scope and bolt then measure height.

Originally Posted by Longrun

I'm going to try medium talleys with a 40mm objective to see if I get less suppressor in the sight picture.

These work out good. Only 3.5mm higher than lows and no suppressor in sight picture on 3x