Printable View
Hi all, clearance question here. going to mount a 50mm glass to a tikka 7mm 08 and want it low but obviously not touching
going with Talley direct mounts (30mm) and unsure of the ring height to go for ive read
all the usual manufacturers recomendationms....but wonder if they air on the side of caution re clearance.
does anyone have any direct experience here?
What are you saying here?
fluffed post. edited now
Talley lows should do it. You can use extra lows with the likes of a VX6 3-18x44.
pretty rifle dependent but i would go medium myself have 42/44 scopes mounted in lows and almost need medium's on my bergara which is pretty different obviously to a tikka profile
I have just got low Talleys for a T3 to run a 50mm objective Swarovski z5. (1" tube).
Lows should be fine. Think I even got away with ultra lows once. Depends on how you had the eye relief. Scope too far back didn't work with the ultra lows . But was fine how I needed it, being slightly forward.
Sent from my SM-A145F using Tapatalk
I'm going to try medium talleys with a 40mm objective to see if I get less suppressor in the sight picture.
Got to be careful with that as it will end up to abit high and trying to get a proper check weld will be abit of a prick and depending on the scope and the magnification range lower mags it wont make bugger all difference having it 4-6mm higherQuote:
Originally Posted by Longrun
I have a athlon 2-12 on my bergara 308 and at 2x i have the suppressor in the sight picture but its no issue have to go up to 4-5x to get no suppressor in sight picture
Get Talley lows any higher and you will need a cheek riser
Sent from my CPH2531 using Tapatalk
Yeah, we'll see. It's only a few mm differenceQuote:
Originally Posted by Carbine
Get some plasticene, make 2 blobs and place on top of receiver then put your scope on top and squeeze down so still got 2mm of clearance for scope and bolt then measure height.
got lows for tikka and vx5 3-15
These work out good. Only 3.5mm higher than lows and no suppressor in sight picture on 3xQuote:
Originally Posted by Longrun
All my tikkas run mediums with 44 and 56mm scopes as I find that's the best cheek weld for me