Printable View
Currently rebarreling an old Blued Rem 700 308 Target/Tactical for a client, pulled the old barrel off & found this....
http://i1004.photobucket.com/albums/...psgkfekbud.jpg
When going into the receiver cock in a sock doesn't even begin to describe the first 3/4's of the thread, :wtfsmilie:
It has been abused & had a besquillion rounds through it, used to shoot fantastically, easily 1/2 moa & better right out there :)
Bit of threadtape and she be good as new
Looks like you stripped half the thread taking it off mate! Probably still in the thread of the action :P
Looks like your typical tapered pipe threading. Oh, yes, Remington. Probably found a bit of old pipe leaning against the wall at the back of the factory.
Is that BSP or maybe NPT being a yank :)
Actually it's quite an impressive bit of machining to get the bottom of the end threads flat whilst also reducing the thread depth. Not just a matter of machining a tapered thread.
Goes to show that over engineering is not always better if 4 threads hold ok why have more?
there's at least 4 good threads for full engagement... easily be able to torque that up to 100 ft/lb :thumbsup:
used to shoot fantastically, easily 1/2 moa & better right out there
Obviously that's the answer to accuracy, so what's the problem?:)
Floating barrel at both ends
3 threads (depending on pitch and other stuff) is all that is needed for maximum strength (tensile) in theory, also a 25% reduction in thread height from the tops and bottoms of the thread only results in a 9% reduction in strength.'Quote:
Originally Posted by Marty Henry
That said the main consideration of a barrel threaded into an action is not thread strength....
The thread pictured sure is an interesting one....looks to me like the one thread has been turned at not one but two pitches close to the same and as the pitches diverge less thread is left.
Yup that's close to what I know bout threads-60% of the thread is 90% of the strength etc.Quote:
Originally Posted by veitnamcam
I was thinking the same thing about the thread-it looks like it was the wrong thread pitch by maybe 1 tpi
a north korean attempt at manufacturing and fitting a .303 barrel no doubt.
its just a method of lightening the rifle that's all
DAH! it's RSBT - Remington Standard Barrel Thread !!
I have no idea what I am looking at and even less of an idea why it matters. If it shot 1/2 Moa then she was good enough to knock the nuts off of a gnat at 100 paces. Why fuck with perfection?
Because the barrel is shot out :)Quote:
Originally Posted by Rushy
Oh! Then put a new barrel on it man. Ha ha ha ha Rushy the armourer talking it up big time.Quote:
Originally Posted by Kiwi Greg
I might have had a hand in that if it is the rifle I am thinking of.....................Quote:
Originally Posted by Kiwi Greg